Loading Rollback Configuration Changes To The Target Configuration - Cisco ASR 9000 Getting Started Manual
Cisco systems router getting started guide
Hide thumbs
Also See for ASR 9000:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Managing Configuration History and Rollback
Unlike the rollback process, loading the commitID configuration changes loads only the changes made
Note
during that commit operation. The load process does not load all changes made between the commitID
and the current committed configuration.
To load commitID changes in the target configuration, go to global configuration or administration
configuration mode and type the load commit changes command with the commitID number. In the
following example, show commands are used to display the changes for a commitID, the commitID
configuration is loaded into the target configuration, and the target configuration appears:
RP/0/RSP1/CPU0:router# show configuration commit changes ?
last
since
1000000217
1000000218
1000000219
1000000220
1000000221
RP/0/RSP1/CPU0:router# show configuration commit changes 1000000219
Building configuration...
interface Loopback100
!
interface Gi0/1/0/0
ipv4 nd dad attempts 50
!
end
RP/0/RSP1/CPU0:router# config
RP/0/RSP1/CPU0:router(config)# load commit changes 1000000219
Building configuration...
Loading.
77 bytes parsed in 1 sec (76)bytes/sec
RP/0/RSP1/CPU0:router(config)# show configuration
Building configuration...
interface Loopback100
!
interface Gi0/1/0/0
ipv4 nd dad attempts 50
!
end
Loading Rollback Configuration Changes to the Target Configuration
If the changes for a specific rollback point are close to what you want, but a rollback is not appropriate,
you can load the rollback configuration changes into the target configuration, modify the target
configuration, and then commit the new configuration. Unlike the rollback process, the loaded changes
are not applied until you commit them.
Tip
To display the rollback changes, type the show configuration rollback changes command.
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
4-10
F I N A L D R A F T — C i s c o C o n f i d e n t i a l
Changes made in the most recent <n> commits
Changes made since (and including) a specific commit
Commit ID
Commit ID
Commit ID
Commit ID
Commit ID
Chapter 4
Configuring Additional Router Features
OL-17502-01
Advertisement
Table of Contents
