Related Documents; Manually Setting The Router Clock - Cisco ASR 9000 Getting Started Manual
Cisco systems router getting started guide
Hide thumbs
Also See for ASR 9000:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Manually Setting the Router Clock
Related Documents
Related Topic
Additional information about configuring management
interfaces
Manually Setting the Router Clock
Generally, if the system is synchronized by a valid outside timing mechanism, such as a Network Time
Protocol (NTP) or VINES clock source, you need not set the software clock. Use the clock set command
for initial configuration or if a network time source is not available.
The clock timezone command should be entered before the clock is set because it defines the difference
between the system time and Coordinated Universal Time (UTC). When you set the time, you set the
system time, and the router uses the clock timezone command setting to translate that time to UTC. The
system internally keeps time in UTC. When you type the show clock command, the router displays the
system time.
To manually set the router clock, complete the following steps:
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
3-38
F I N A L D R A F T — C i s c o C o n f i d e n t i a l
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
configure
clock timezone zone hours-offset
commit
end
clock set hh:mm:ss dd mm yyyy
clock update-calendar
show clock
Chapter 3
Document Title
Cisco ASR 9000 Series Aggregation Services Router
Interface and Hardware Component Configuration Guide
Configuring General Router Features
OL-17502-01
Advertisement
Table of Contents
