Subscriber Rules; Service Rules - Cisco ASR 5000 Administration Manual
Staros release 21.1
Hide thumbs
Also See for ASR 5000:
- Installation manual (294 pages) ,
- Administration manual (159 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
Subscriber Rules
• Up to 12 charging gateway functions (CGFs) for GTPP accounting can be configured per context.
• Up to 16 bidirectional forwarding detection (BFD) sessions per context (64 per chassis)
Important
Subscriber Rules
The following engineering rules apply to subscribers configured within the system:
• Configure a maximum of 2,048 local subscribers per context.
• You may configure attributes for each local subscriber.
• The system creates a default subscriber for each context when the context is made. Configure attributes
• Configure default subscriber templates on a per AAA realm (domain aliases configured within a context)
• Configure default subscriber templates on a per PDSN, FA, ASN-GW, or HA service.
• For AAA authenticated subscribers, the selection of local subscriber template to use for setting attributes
Service Rules
The following engineering rules apply to services configured within the system:
• Configure a maximum of 256 services (regardless of type) per system.
ASR 5000 System Administration Guide, StarOS Release 21.1
370
Refer to Engineering Rules in your product administration guide for additional information on
product-specific operating limits.
for each default subscriber. If a AAA-based subscriber is missing attributes in the authentication reply
message, the default subscriber attributes in the context where the subscriber was authenticated are used.
Default is not used when local authentication (for local subscribers) is performed.
Important
basis.
is in the following order:
• If the username (NAI) matches any local domain name and the domain name has a local subscriber
name configured, that local subscriber template is used.
• If the first case fails, and if the serving service has a default username configured, that subscriber
template is used.
• If the first two cases fail, the default subscriber template in the AAA context is used.
Engineering Rules
Advertisement
Table of Contents
Troubleshooting
