Connecting The Phone To Power - Cisco 7960G Administrator's Manual
Sip
Hide thumbs
Also See for 7960G:
- Administration manual (184 pages) ,
- User manual (122 pages) ,
- Phone manual (74 pages)
Table of Contents
Advertisement
Connecting the Phone to Power
Connecting the Phone to Power
Read the installation instructions before you connect the system to its power source.
Warning
Waarschuwing Raadpleeg de installatie-aanwijzingen voordat u het systeem met de voeding verbindt.
Varoitus Lue asennusohjeet ennen järjestelmän yhdistämistä virtalähteeseen.
Attention Avant de brancher le système sur la source d'alimentation, consulter les directives
d'installation.
Warnung Lesen Sie die Installationsanweisungen, bevor Sie das System an die Stromquelle
anschließen.
Avvertenza Consultare le istruzioni di installazione prima di collegare il sistema all'alimentatore.
Advarsel Les installasjonsinstruksjonene før systemet kobles til strømkilden.
Aviso Leia as instruções de instalação antes de ligar o sistema à sua fonte de energia.
¡Advertencia! Ver las instrucciones de instalación antes de conectar el sistema a la red de alimentación.
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess strömförsörjningsenhet.
When you connect the phone to power, the phone automatically begins startup and initialization. Use
Caution
this section to determine how you will power your phones. Do not connect the phones to power, though,
until you address the prerequisites and follow the configuration instructions in
Cisco SIP IP Phones."
You can connect the Cisco IP phone to the following power sources:
•
•
•
•
•
•
•
Note
•
•
Cisco SIP IP Phone Administrator Guide, Release 6.x and 7.x
2-4
External power source—Optional AC adapter and power cord for connecting to a standard wall
receptacle.
WS-X6348-RJ45V 10/100 switching module—Provides inline power to the phone when connected
to a Cisco Catalyst 3500, 4000, or 6000 family 10/100BASE-TX switching module. This module
sends power on pins 1 and 2, and 3 and 6.
WS-PWR-PANEL—Power patch panel provides power to the phone, which allows the phone to be
connected to existing Cisco Catalyst 4000, 5000, and 6000 family 10/100BASE-TX switching
modules. This module sends power on pins 4, 5, 7, and 8.
WS-X4148-RJ45V—48-port 10/100 Ethernet with inline power module for the Cisco Catalyst 4006
switch.
WS-X4095-PEM—VoIP DC Power Entry module for the Cisco Catalyst 4006 switch.
WS-X4608-2PSU and WS-X4608—External –48VDC power shelf common equipment for the
Cisco Catalyst 4006 with two AC-to-DC power supply units (PSUs) and one empty bay for
redundant option, and the 110-V 15-A AC-to-48VDC PSU redundant option for the power shelf.
WS-C3524-PWR-XL-EN—Cisco Catalyst 3524-PWR XL switch.
Only the network port (labeled 10/100 SW) supports inline power from the Cisco Catalyst switches.
If you are using a Cisco Catalyst switch to provide power, see the
Catalyst Switch" section on page
Chapter 2
Installing Cisco IP 7960G/7940G Phone Hardware on the Desktop or Wall
2-3.
Chapter 3, "Initializing
"Using the Phone with a Cisco
Advertisement
Table of Contents
