Chapter 5 Monitoring Cisco Sip Ip Phones; How To Use The Command-Line Interface To Monitor Phones - Cisco 7960G Administrator's Manual
Sip
Hide thumbs
Also See for 7960G:
- Administration manual (184 pages) ,
- User manual (122 pages) ,
- Phone manual (74 pages)
Table of Contents
Advertisement
Monitoring Cisco SIP IP Phones
This chapter provides information on the following:
•
•
How to Use the Command-Line Interface to Monitor Phones
You can use Telnet or a console to connect to your Cisco IP 7960G/7940G phone, and you can and use
the command-line interface (CLI) to debug or troubleshoot the phone.
commands and their syntax.
Note
•
•
•
Table 5-1
How to Use the Command-Line Interface to Monitor Phones, page 5-1
How to Use the Phone Menus to Access Status Information, page 5-18
You need the phone IP address to use the CLI in a Telnet session. To get the IP address, select
Settings > Network Configuration > IP Address. The default Telnet password is "cisco."
You can conduct only two Telnet sessions at any time.
The phone cannot originate a Telnet session to another address.
describes the available commands.
C H A P T E R
Table 5-1
Cisco SIP IP Phone Administrator Guide, Release 6.x and 7.x
5
shows the available CLI
5-1
Advertisement
Table of Contents
