Cisco 7960G Administrator's Manual page 49
Sip
Hide thumbs
Also See for 7960G:
- Administration manual (184 pages) ,
- User manual (122 pages) ,
- Phone manual (74 pages)
Table of Contents
Advertisement
Chapter 3
Initializing Cisco SIP IP Phones
•
If the telnet_level parameter is set to allow privileged commands to be executed, the entire SIP
configuration can be erased. Use the erase_protflash command so that the phone can retrieve its
configuration files.
Prerequisites
Define the line parameters (those identified as linex) on the phone. If you configure a line to use an
•
e-mail address, that line can be called only by using an e-mail address. Similarly, if you configure a
line to use a number, that line can be called only by using the number.
Procedure
Step 1
Unlock the phone (see the
Select Settings > SIP Configuration. The SIP Configuration menu displays.
Step 2
To set a required parameter, select it and set it as desired. The following are required parameters that you
Step 3
must set now if you did not set them in the default configuration file as described in the
Customize the Default Configuration File" section on page
line1_name—Number or e-mail address for use when registering. Enter a number without dashes.
•
For example, enter 555-0100 as 5550100. Enter an e-mail ID without the host name.
proxy1_address—IP address of the SIP proxy server that is used by the phones. Enter the address in
•
IP dotted-decimal notation or use the FQDN. The "x" argument is representative of server addresses.
If the parameter is provisioned with an FQDN, the phone sends REGISTER and INVITE messages
by using the FQDN in the Req-URI, To, and From fields.
proxy1_port—Port number of the SIP proxy server that is used by line 1.
•
If the proxy server with which the phone communicates has authentication enabled, set the following
•
parameters as well:
–
–
Step 4
To set an additional parameter, select it and set it as desired. Phone-specific parameters are listed in
Table
Step 5
To restore a parameter to its default, do the following:
One at a time, highlight the parameter whose setting you want to erase, and then select Edit followed
a.
by <<.
b.
Select Validate > Exit.
c.
If necessary, select Back to exit the menu.
Select Save. The phone programs the new information into flash memory and resets.
Step 6
Step 7
Relock the phone.
"Unlocking and Locking the Phone" section on page
line1_authname—Name used by the phone for authentication if a registration is challenged by
the proxy server during initialization. Default is UNPROVISIONED.
line1_password—Password used by the phone for authentication if a registration is challenged
by the proxy server during initialization. Default is UNPROVISIONED.
3-3.
How to Customize the Configuration from the Phone Menu
3-5:
Cisco SIP IP Phone Administrator Guide, Release 6.x and 7.x
3-11).
"How to
3-15
Advertisement
Table of Contents
