Cisco 7960G Administrator's Manual page 168
Sip
Hide thumbs
Also See for 7960G:
- Administration manual (184 pages) ,
- User manual (122 pages) ,
- Phone manual (74 pages)
Table of Contents
Advertisement
Table D-1
Parameter
start_media_port
stutter_msg_waiting
sync
telnet_level
tftp_cfg_dir
time_format_24hr
time_zone
timer_invite_expires
Cisco SIP IP Phone Administrator Guide, Release 6.x and 7.x
D-14
Configuration File Parameters (continued)
Description
(Optional) Start RTP range for media.
Range is from 16384 to 32766. Default is 16384.
(Optional) Enables a stutter dial tone when there is a message
waiting. It is disabled by default.
Valid values are 0 (off) and 1 (on).
(Optional) Value against which to compare the value in the
syncinfo.xml file before a remote reboot is performed. Limited to 32
characters.
(Optional) Enables Telnet for the phone.
Valid values are as follows:
•
•
•
Default is 0.
Path to the TFTP subdirectory in which phone-specific
configuration files are stored.
Note
(Optional) Whether a 12- or 24-hour time format is displayed by
default on the user interface.
Valid values are as follows:
•
•
•
•
Default is 1.
(Optional) Time zone in which the phone is located.
Valid values are the time-zone abbreviations shown in
page
capital letters. Default is PST.
(Optional) Amount of time, in seconds, after which a SIP INVITE
expires. This value is used in the Expire header field.
Valid values are any positive number; however, we recommend 180.
Default is 180.
Appendix D
0—Disabled.
1—Enabled, and no privileged commands can be executed.
2—Enabled, and privileged commands can be executed.
This parameter is only required if the phone-specific files
are in a subdirectory and not in the root directory.
0—12-hour format is displayed by default but can be changed
to a 24-hour format using the user interface.
1—24-hour format is displayed by default but can be changed
to a 12-hour format using the user interface.
2—12-hour format is displayed and cannot be changed to a
24-hour format using the user interface.
3—24-hour format is displayed and cannot be changed to a
12-hour format using the user interface.
3-20. Abbreviations are case sensitive and must be in all
Configurable Parameters for the SIP IP Phone
Table 3-5 on
Advertisement
Table of Contents
