Installing The Bracket - Cisco 8961 Administration Manual
Administration guide for cisco unified communications manager 8.6 (sip)
Hide thumbs
Also See for 8961:
- Administration manual (378 pages) ,
- User manual (180 pages) ,
- Features (35 pages)
Table of Contents
Advertisement
Appendix E
Installing the Wall Mount for the Cisco Unified IP Phone
Installing the Bracket
To install the phone on the wall, perform the following steps:
Be sure to connect to connect the Cisco Unified IP Phone to the Key Expansion Module before installing
Note
the phone bracket.
Procedure
Mount the wall bracket in the desired location
Step 1
jack, or you can run the Ethernet network cable to a jack nearby.
a.
b.
c.
d.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
Use the level to ensure the bracket is level, then use a pencil to mark the screw holes.
Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the
anchor into the wall.
Screw the anchor clockwise into the wall until it is seated flush.
Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.
Installing a Wall Mount for a Phone with a Key Expansion Module
(Figure
E-8). You can install the bracket over an Ethernet
E-9
- Quick Links:
- Unlocking and Locking Options
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
