Before You Begin; Installing The Bracket - Cisco 8961 Administration Manual
Administration guide for cisco unified communications manager 8.6 (sip)
Hide thumbs
Also See for 8961:
- Administration manual (378 pages) ,
- User manual (180 pages) ,
- Features (35 pages)
Table of Contents
Advertisement
Installing the Wall Mount for Cisco Unified IP Phone 8961, 9951, and 9971
•
•
•
Before You Begin
You need these tools to install the bracket:
•
•
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does
not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a
regular telephone jack. For more information about phone installation requirements and warnings, see
the
Installing the Bracket
To install the phone on the wall, perform the following steps:
Procedure
Mount the wall bracket in the desired location
Step 1
jack, or you can run the Ethernet network cable to a jack nearby.
a.
b.
c.
d.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
E-2
2 4-40x1/4 inch machine screws
1 six-inch Ethernet cable
1 key if the bracket includes the optional lock
#1 and #2 Phillips-head screwdrivers
Level
Setting Up the Cisco Unified IP Phone
Use the Level to ensure the bracket is level, then use a pencil to mark the screw holes.
Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the
anchor into the wall.
Screw the anchor clockwise into the wall until it is seated flush.
Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.
Appendix E
Installing the Wall Mount for the Cisco Unified IP Phone
chapter.
(Figure
E-2). You can install the bracket over an Ethernet
- Quick Links:
- Unlocking and Locking Options
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
