Table of Contents
Advertisement
When placing the Original on the document glass:
1
Confirm that there are no original(s) in
the RSPF, and open the RSPF.
2
Place the original face down on the
document glass. Align the original
according to the original scale in the
illustration below. (Line up the center
of the edge of the original with the
(
) mark.)
Original
scale
mark
3
Gently close the RSPF.
When using the document glass, do not set
Note
original(s) in the RSPF.
4
If needed, set the original size (p.54),
resolution (p.55), and contrast (p.55).
Continue with the "DIALING AND
TRANSMITTING" (p.59) section.
HOW TO USE THE FAX FUNCTION
5
Press the [START] key (
After the [START] key (
Note
set original size appears in the display.
(EX. )
READING
8.5x11
Make sure that the displayed size is the
same as the actual original size. (The
factory default setting for the original size is
"8.5x11".) If the displayed size is not correct,
press the [CLEAR ALL] key (
operation and then change the original size
setting. (See "ORIGINAL SIZE" (p.54))
When faxing from the document glass, if the
size of the original is different from the
specified size, part of the image may be cut
off.
6
If you have more than one original to
read into memory, place the next
page, and press the [START] key (
to read each page.
Go to step 7 after the last page has been
scanned.
7
Press the [#] key.
).
The set original size
appears in the display
and then scanning
begins.
) is pressed, the
#001
100%
) to stop
)
Transmission begins.
53
4
Advertisement
Table of Contents
Troubleshooting
