Table of Contents
Advertisement
ABOUT THE LIQUID CRYSTAL DISPLAY
The machine is equipped with a two-line liquid crystal display (LCD) on the operation panel for displaying various
messages and settings during operation. This LCD can display up to 20 characters on each line. When the machine
is idle, the LCD shows the date, time, reception mode and the stand-by memory available.
Example:
When the [MENU] key is pressed to configure a setting, the display appears as shown below.
Example:
USING THE ARROW KEYS
To configure settings and program information, press the [MENU] key and then press the [
key (
) to select the item that you wish to configure.
The arrows keys can also be used while entering characters to move the cursor.
Example:
An item can also be selected after pressing the [MENU] key by pressing the numeric key for the item
Note
(the key corresponding to the number that appears in front of the item). When the numeric key is
pressed, the item is selected or entered.
ADJUSTING THE BEEP VOLUME
You can adjust the volume of the beep that sounds when a key is pressed.
The key beep volume is adjusted with "KEY TOUCH SOUND" (Program number 15) in the user programs of copy
mode. See "User Programs" in the Operation Manual (for general information).
16
When an original is placed in the RSPF, the second line
changes from "STAND-BY" to "SEND READY".
The selected setting or entered information appears on the
second line.
Press the [
] key (
item selection that appears on the second line.
] key (
) or [
] key (
) to change the
) or [
]
Advertisement
Table of Contents
Troubleshooting
