hit counter script
Zanussi ZDT 311 User Manual
  1. Manuals
  2. Brands
  3. Zanussi Manuals
  4. Dishwasher
  5. ZDT311
  6. User manual
Zanussi ZDT 311 User Manual

Zanussi ZDT 311 User Manual

Hide thumbs Also See for ZDT 311:
Table of Contents

Advertisement

Quick Links

See also: User Manual
User manual
Dishwasher
ZDT 311

Advertisement

Table of Contents
loading

Related Manuals for Zanussi ZDT 311

Summary of Contents for Zanussi ZDT 311

  • Page 1 User manual Dishwasher ZDT 311...

  • Page 2: Table Of Contents

    Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.

  • Page 3: Safety Information

    Safety information In the interest of your safety and to ensure the ried out by inexperienced persons will cause correct use, before installing and first using the injury or serious malfunctioning. Contact appliance, read this user manual carefully, in- your local Service Force Centre. Always in- cluding its hints and warnings.

  • Page 4: Control Panel

    Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
  • Page 5 In addition to the dishwashing programme se- – activating/deactivating the rinse aid lection, the following functions can also be set dispenser, with the help of these buttons: the appliance MUST be in setting mode: • the setting of the water softener, •...

  • Page 6: Audible Signals

    Audible signals Audible signals have been introduced to help 3. Press function button C, the lights of func- indicate which operations the dishwasher is tion buttons A and B turn off while the light performing: of function button C goes on flashing. At the same time the end of programme in- •...
  • Page 7 4. Press the button corresponding to the re- Attention! Hot steam may escape when the quired programme (see "Washing pro- door is opened. Open the door carefully. grammes" chart). Interrupt a washing programme in pro- When a programme has been selected the gress: corresponding light will illuminate.

  • Page 8: Washing Programmes

    IMPORTANT! plugged and the water tap turned off. When the washing programme has finished, it is recommended that the dishwasher is un- Washing programmes Programme Cycle description Intensive 70° Heavy soil. Prewash Crockery, cutlery, pots and pans Main wash 2 intermediate rinses Final rinse Normal / Light soil.

  • Page 9: First Use

    adjusted between 45°C and 70°C depending on the amount of soil on the dishes. First use • Pour 1 litre of water inside the salt container Before using your dishwasher for the first time: and then fill with dishwasher salt •...

  • Page 10: Setting The Water Softener

    Water hardness Adjusting the water hardness Use of salt setting °dH °TH mmol/l manually electronically 4 - 10 7 - 18 0,7 - 1,8 level 2 < 4 < 7 < 0,7 level 1 The water softener must be set in both ways: manually, using the water hardness dial and electronically.

  • Page 11: Filling With Dishwasher Salt

    3. Press function button A, the lights function 6 flashes / 6 intermittent audible signals, buttons B and C turn off while the light of pause, etc...= level 6 function button A goes flashing, at the 4. To change the level press the function but- same time the end of programme indica- ton A.

  • Page 12: Filling With Rinse Aid

    IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT! Top up the special salt when the light on the control panel illuminates.

  • Page 13: Adjusting The Dosage Of Rinse Aid

    CAUTION! Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. Top up the rinse aid indica- tor (B) becomes clear Adjusting the dosage of rinse aid Increase the dose if there are drops of water or Reduce the dose if there are whitish streaks on lime spots on the dishes after washing.
  • Page 14 that water cannot collect in the container • Plastic items and pans with non stick coat- or a deep base. ings have a tendency to retain water drops; these items will not dry as well as porcelain – Dishes and items of cutlery must not lie and steel items.
  • Page 15 Load cutlery. For best re- Place knives and other Load the lower basket. Ar- sults we recommend you items of cutlery with sharp range serving dishes and to use the cutlery grid pro- points or edges with their large lids around the edge vided (if the size and di- handles facing upwards.

  • Page 16: Use Of Detergent

    Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper bas- ket to the higher position. Maximum height of the dishes in: upper basket lower basket With upper basket raised 20 cm 31 cm...

  • Page 17: Multi-Tab Function

    Open the lid. Fill in the detergent in Observe the dosing lev- compartment A. els. For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in com- tablets in compartment A. partmentB.
  • Page 18 This appliance is equipped with the "Multi-Tab IMPORTANT! function", that allows the use of the "Multi-Tab If the drying results are not satisfactory we sug- " combi detergent tablets. gest that you: These products are detergents with a combined 1. Fill up the rinse aid dispenser with rinse aid. cleaning, rinsing and salt functions.

  • Page 19: Unloading The Dishwasher

    IMPORTANT! 4. Adjust the water hardness setting accord- ing to the hardness of the water in your If you decide to turn back to the use of standard area. detergent system we advise that you: 5. Adjust the rinse aid dosage. 1.

  • Page 20: Cleaning The Spray Arms

    Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing com- water. move filters B and C. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle...

  • Page 21: Environmental Concerns

    2. Leave the door ajar to prevent the forma- 1. Unplug it. tion of any unpleasant smells. 2. Turn the water tap off. 3. Leave the inside of the machine clean. 3. Remove the water inlet and discharge ho- ses. Frost precautions 4.

  • Page 22: Something Not Working

    Something not working The dishwasher will not start or stops during solved with the help of the indications described operation. in the chart, without calling out an engineer. Certain problems are due to the lack of simple Switch off the dishwasher and carry out the fol- maintenance or oversights, which can be lowing suggested corrective actions.
  • Page 23 If the malfunction or fault code reappears con- For other fault codes not described in the above tact the Service Force Centre. chart, please contact your Service Force Cen- tre. The wash results are not satisfactory The dishes are not clean •...

  • Page 24: Consumption Values

    Consumption values The consumption values are intended as a iations of the power supply and the amount of guide and depends on the pressure and the dishes. temperature of the water and also by the var- Consumption values Programme Programme duration (in Energy consumption (in Water (litres) minutes)

  • Page 25: Installation

    rinse aid respectively and using the test pro- gramme (see "Consumption values"). Full load: 12 standard place settings Amount of detergent required 5 g + 25 g (Type B) Rinse aid setting position 4 (Type III) Upper basket Cutlery basket Lower basket cup racks: position A Installation...
  • Page 26 WARNING! WARNING! Only use, for connection to the water mains, The electrical cable for the safety valve is in the new hose-set; old hose-set must not be reused. double-walled water inlet hose and is live. Therefore do not immerse the water inlet hose CAUTION! or the safety valve in water.

  • Page 27: Drain Hose

    Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. cm above bottom of the not kinked, crushed or en- drain hose to an under dishwasher. tangled. sink trap spigot, the entire plastic membrane (A) must be removed.

  • Page 28: Fitting Under A Counter

    Fitting under a counter The dishwasher incorporates adjustable feet to allow the adjustment of the height. IMPORTANT! During all operations that involve accessibility to internal components the dishwasher has to Carefully follow the instructions on the enclosed be unplugged. template for building in the dishwasher and fit- Be sure that once the appliance has been in- ting the furniture panel.
  • Page 32 www.electrolux.com 156992690-00-05102007 Subject to change without notice...

Table of Contents