Table of Contents
Advertisement
Using a Handset, Headset, and Speakerphone
The table below describes how to use these devices.
If you want to...
Use the handset
Use a headset
Use the speakerphone
Switch to the speakerphone or
headset (from the handset)
during a call
Switch to the handset (from the
speakerphone or headset)
during a call
Tips
• See the "Connecting Your Phone" section on page 5 to locate the headset port.
• See the "Basic Call Handling" section on page 17 for detailed instructions about how to use the
handset, headset, and speakerphone to place, answer, end, and otherwise handle calls.
Obtaining a Headset
Your phone supports four- or six-wire headset jacks. For information about purchasing headsets, see
the "Headset Information" section on page 6 and go to the following URL: http://vxicorp.com/cisco
Cisco IP Phone 7960G and 7940G
Then...
Lift it to go off-hook; replace it to go on-hook.
Press
to toggle headset mode on and off. (AutoAnswer users
should see the "Using AutoAnswer with a Headset or the
Speakerphone" section on page 34 for exceptions.)
You can use the headset in conjunction with all of the controls on
your phone, including
See the "Obtaining a Headset" section on page 33 for headset
purchasing information.
Press
to toggle speakerphone mode on or off.
Many of the actions you can take to dial a number or answer a call
will automatically trigger speakerphone mode, assuming that the
handset is in its cradle and
Press
or
, then hang up the handset.
Lift the handset. There is no need to push any buttons.
Using a Handset, Headset, and Speakerphone
and
.
is not lit.
33
Advertisement
Table of Contents
