Table of Contents
Advertisement
If you want to...
Remove any conference
participant
End your participation in a
standard conference
Tips
• Calls must be on the same line before you can add them to a standard conference call. If calls are
on different lines, transfer them to a single line before using Confrn or Join.
• If you get an error stating, "No Participant Info" when attempting to use Join, be sure that you
have selected at least one call in addition to the active call, which is selected automatically.
• Depending on how your phone is configured, if you leave a conference after creating it, the
conference might end. See the last row of the above table for more information.
Starting or Joining a Meet-Me Conference Call
Use Meet-Me conferences to start a conference (up to 100 parties, depending on configuration) that
requires participants to call an established number at a specific time. This is an optional feature that
your system administrator must configure for you.
If you want to...
Establish a Meet-Me
conference
Participate in a Meet-Me
conference
End a Meet-Me conference
26
Then...
Highlight the participant's name and press Remove. You can remove
participants only if you initiated the conference call.
Hang up or press EndCall. If you did not initiate the conference call,
hanging up will not disrupt the connection for the remaining parties.
If you initiated the conference call, hanging up might end the
conference (depending on how your system administrator configured
your phone). To avoid this, you can transfer the conference to
another caller before hanging up. That caller then acts as the "virtual
controller" for the conference. A virtual controller cannot add or
remove parties; however, the conference continues with the
established participants.
Then...
Press Meet-Me. (You may need to press the more softkey to see
Meet-Me.) Dial the Meet-Me conference number provided by your
system administrator, then follow the voice instructions.
Dial the Meet-Me conference number provided by the conference
initiator. You can join after the initiator has established the conference.
(The Meet-Me softkey is not used to join the conference.)
Hang up or press EndCall.
OL-4637-02
Advertisement
Table of Contents
