Performing A Basic Configuration Using Global Configuration Mode - Cisco 7206VXR - VPN Bundle Router Configuration Manual
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Configuring a Cisco 7200 VXR Router
half-duplex
ip address 1.1.1.20 255.0.0.2
appletalk cable-range 0-0 0.0
appletalk discovery
!
interface serial3/0
ip address 1.1.1.30 255.0.0.3
ip route-cache cbus
no keepalive
!
!
router igrp 15
network 1.0.0.0
!
end
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
Your router is now minimally configured and ready to use. You can use the setup command if you want
to modify the parameters after the initial configuration. To perform more complex configurations, use
the configure command.
For information on additional interface configuration and specific system configurations, refer to the
modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco
hardware.
Performing a Basic Configuration Using Global Configuration Mode
You can configure a Cisco 7200 VXR router manually if you prefer not to use the setup facility or
AutoInstall. Complete the following steps to configure the router manually:
Connect a console terminal to the console port on the I/O controller.
Step 1
When asked if you want to enter the initial dialog, answer no to go into the normal operating mode of
Step 2
the router:
Would you like to enter the initial dialog? [yes]: no
Step 3
After a few seconds the user EXEC prompt
(configuration changes can only be made in enable mode):
Router> enable
The prompt changes to the privileged EXEC prompt:
Router#
Step 4
Enter the config terminal command at the enable prompt to enter configuration mode from the terminal:
Router# config terminal
Enter configuration commands, one per line.
Router(config)#
At the
configuration mode:
Cisco 7200 VXR Installation and Configuration Guide
4-14
prompt, enter the interface type slot/port command to enter the interface
Router(config)#
Chapter 4
Observing System Startup and Performing a Basic Configuration
is displayed. Type enable to enter enable mode
(Router>)
End with CNTL/Z.
OL-5013-09
Advertisement
Table of Contents
Troubleshooting
