Configuring Fast Ethernet Interfaces - Cisco 7206VXR - VPN Bundle Router Configuration Manual
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Chapter 4
Observing System Startup and Performing a Basic Configuration
Step 2
Determine if you are going to enable IPX on this interface; if you are, enter the unique IPX network
number:
Configure IPX on this interface? [no]: yes
If you are using AppleTalk on the interface, enter yes. Enter yes to configure for extended AppleTalk
Step 3
networks, and then enter the cable range number. Enter the zone name and any other additional zones
that are associated with your local zone:
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]:
If additional ATM interfaces are available in your system, you are prompted for their configurations as
Note
well.
Save your settings to NVRAM. (See the
Step 4
page
Configuring Fast Ethernet Interfaces
In the following example, a Fast Ethernet interface in slot 2 is configured for a Fast Ethernet LAN using
IP. Follow these steps to configure Fast Ethernet interfaces.
Using your own addresses and mask at the setup prompts, respond to the prompts as follows:
Step 1
Configuring interface parameters:
Configuring interface FastEthernet2/0:
Is this interface in use? [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [yes]:
Determine if you are going to enable IPX on this interface; if you are, enter the unique IPX network
Step 2
number:
Configure IPX on this interface? [no]: yes
If you are using AppleTalk on the interface, enter yes. Enter yes to configure for extended AppleTalk
Step 3
networks, and then enter the cable range number. Enter the zone name and any other additional zones
that are associated with your local zone:
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]:
OL-5013-09
IPX network number [2]:
4-15.)
IP address for this interface: 1.1.1.20
Number of bits in subnet field [0]:
Class C network is 1.1.1.0, 0 subnet bits; mask is /24
IPX network number [2]:
"Saving the Running Configuration to NVRAM" section on
Cisco 7200 VXR Installation and Configuration Guide
Configuring a Cisco 7200 VXR Router
4-11
Advertisement
Table of Contents
Troubleshooting
