Installing The Npe-G1 And Npe-G2 Cable-Management Brackets On A Rear-Mounted Router - Cisco 7206VXR - VPN Bundle Router Configuration Manual
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Chapter 3
Installing a Cisco 7200 VXR Router
To prevent injury, review the safety precautions in
Caution
installing the router in a rack.
Installing the NPE-G1 and NPE-G2 Cable-Management Brackets on a Rear-Mounted Router
Use the instructions in this section to attach the standard cable-management brackets if you have a
rear-mounted router.
If you wish to install the NPE-G1 or NPE-G2 optical cable-management bracket, see the
NPE-G1 and NPE-G2 Optical Cable-Management Bracket" section on page
Figure 3-12
1
If you have an NPE-G1 or NPE-G2 installed, you will want to install cable-management brackets on the
rear of the router as well as on the front of the router.
Align the cable-management brackets with the rack-mount brackets.
Step 1
Insert and tighten two screws for each bracket. The screws come with the cable-management brackets.
Step 2
This completes the procedure for installing the rack-mount brackets and cable-management brackets on
a Cisco 7200 VXR router. Proceed to the
OL-5013-09
Installing the Rear Cable-Management Brackets with the NPE-G1 or NPE-G2—Router
Rear-Mounted
1
G I G A B I T E T H E R N E T 0 / 1
L I N K
E N
R J 4 5
R X
G B I C
Cable-management bracket screws
Chapter 2, "Preparing for Installation,"
G I G A B I T E T H E R N E T 0 / 1
G I G A B I T E T H E R N E T 0 / 1
NETWORK PROCESSING ENGINE - G1
L I N K
L I N K
C P U
R E S E T
E N
E N
T X
R J 4 5
R X
G B I C
T X
R J 4 5
R X
G B I C
T X
"Installing the Chassis in the Rack" section on page
Cisco 7200 VXR Installation and Configuration Guide
Rack-Mounting a Cisco 7200 VXR Router
3-11.
1
S L O T
A C T I V E
POWER
C O M PA C T F L A S H
ON
CONSOLE
AUX
before
"Installing the
3-14.
3-13
Advertisement
Table of Contents
Troubleshooting
