Using Show Commands To Check The Installation - Cisco 7206VXR - VPN Bundle Router Configuration Manual
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Using show Commands to Check the Installation
•
•
Using show Commands to Check the Installation
Use show commands to identify the hardware installed in your router, to verify the operation status, to
view interface configuration settings, and to troubleshoot your router configuration. The interfaces on
the NPE-G1 or NPE-G2 are identified by their chassis slot number and interface port number (slot/port).
The interfaces on your I/O controller are also identified by chassis slot number and interface port number
(slot/port). The chassis slot number for the I/O controller is always slot0.
NPE-G2, and the I/O controller models, their corresponding interfaces, and the interface addressing
syntax for each interface.
Table 4-1
Identifying Interface Addresses on the NPE-G1, NPE-G2 and Various I/O Controllers
Model
NPE-G1 or NPE-G2
C7200-I/0-GE+E
C7200-I/0-2FE/E
2
C7200-I/0-FE
C7200-I/0
3
C7200-I/0-FE-MII
1. Both optical and copper ports report the same syntax. For example, Gigabit Ethernet RJ-45 port 0/2 reports GigabitEthernet 0/2, as does Gigabit Ethernet
GBIC port 0/2.
2. The Product Number C7200-I/O-FE does not specify MII because both an MII and an RJ-45 receptacle are included.
3. The I/O controller with the Product Number C7200-I/O-FE-MII has a single MII FastEthernet receptacle only. Although still supported by Cisco Systems,
this I/O controller with a single MII receptacle is no longer an orderable product as of May 1998.
Cisco 7200 VXR Installation and Configuration Guide
4-16
Loading configuration files or system images using remote copy protocol (rcp) or Trivial File
Transfer Protocol (TFTP)
Reloading the operating system
Interface
Gigabit Ethernet (port 0/1)
Gigabit Ethernet (port 0/2)
Gigabit Ethernet (port 0/3)
Gigabit Ethernet (port GE0)
Ethernet (port E0)
Fast Ethernet/Ethernet (port0)
Fast Ethernet/Ethernet (port1)
Fast Ethernet (MII or RJ-45)
No interface ports
Fast Ethernet (MII)
Chapter 4
Observing System Startup and Performing a Basic Configuration
Numbers
1
Chassis slot—always 0
Interface port—1, 2, or 3
Chassis slot—always 0
Interface port—0
Chassis slot—always 0
Interface port—0
Chassis slot—always 0
Interface port—0
Chassis slot—always 0
Interface port—1
Chassis slot—always 0
Interface port—0
—
Chassis slot—always 0
Interface port—0
Table 4-1
lists the NPE-G,
Syntax
Gigabit Ethernet 0/1
Gigabit Ethernet 0/2
Gigabit Ethernet 0/3
gigabitethernet 0/0
fastethernet 0/0
fastethernet 0/0
fastethernet 0/1
fastethernet 0/0
—
fastethernet 0/0
OL-5013-09
Advertisement
Table of Contents
Troubleshooting
