Configuring QoS
Command
Step 5
conform-action {drop |
set-cos-transmit cos_value |
set-discard-class
discard_value |
set-dscp-transmit dscp_value |
set-mpls-exp-imposition-tran
smit new-exp |
set-mpls-exp-topmost-transm
it new-exp | set-prec-transmit
value | set-qos-transmit value |
transmit}
Cisco ME 3800X and 3600X Switch Software Configuration Guide
27-36
Purpose
(Optional) Enter the action to be taken on packets that conform to the CIR.
drop—drop the packet.
•
set-cos-transmit cos_value—set the CoS value to a new value, and send the
•
packet. The range is 0 to 7.
•
set-discard-class-transmit discard_value—set the discard value to a new
value, and send the packet. The range is 0 to 7.
•
set-dscp-transmit dscp_value—set the IP DSCP value to a new value, and
send the packet. The range is 0 to 63. You also can enter a mnemonic name for
a commonly used value or use the question mark (?) to see a list of available
values.
•
set-mpls-exp-imposition-transmit new-exp—enter the new MPLS
experimental value to be set at tag imposition, and send the packet. The range
is 0 to 7.
set-mpls-exp-topmost-transmit new-exp—enter the new MPLS experimental
•
value for the outermost or topmost label, and send the packet. The range is 0
to 7.
set-prec-transmit value—set the IP precedence value to a new value, and send
•
the packet. The range is 0 to 7.
set-qos-transmit value—set the QoS group number to a new value, and send
•
the packet. The range is 0 to 99.
transmit—send the packet without altering it. This is the default.
•
If you are configuring a single action for conformed and exceeded packets,
Note
you can specify them in the same line. If configuring multiple actions, press
ENTER after the conform-action command.
Chapter 27
Configuring QoS
OL-23400-01