Cisco 3845 - Security Bundle Router Software Manual page 437
Software configuration guide
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Manual (94 pages) ,
- Quick start manual (38 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Chapter 25
Configuring SNMP
Note
Many commands use the word traps in the command syntax. Unless there is an option in the command
to select either traps or informs, the keyword traps refers to traps, informs, or both. Use the snmp-server
host global configuration command to specify whether to send SNMP notifications as traps or informs.
Table 25-5
traps and configure a trap manager to receive them.
Table 25-5
Switch Notification Types
Notification Type Keyword
alarms
auth-framework
bgp
bridge
config
config-copy
copy-config
cpu threshold
config
eigrp
envmon
ethernet-cfm
flash
hsrp
ipmulticast
mac-notification
mpls-fast-reroute
mpls-ldp
mpls-traffic-eng
mpls-vpn
msdp
ospf
pim
rtr
snmp
OL-23400-01
describes the supported switch traps (notification types). You can enable any or all of these
Description
Generates alarm traps.
Generates SNMP CISCO-AUTH-FRAMEWORK-MIB traps.
Generates Border Gateway Protocol (BGP) state change traps.
Generates STP bridge MIB traps.
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP configuration copy changes.
Generates a trap for SNMP copy configuration changes.
Generates a trap for CPU threshold violations.
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP EIGRP changes.
Generates environmental monitor traps. You can enable any or all of these environmental
traps: fan, shutdown, status, supply, temperature.
Generates an SNMP Ethernet CFM trap.
Generates SNMP FLASH notifications.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for IP multicast routing changes.
Generates a trap for MAC address notifications.
Generates a trap for MPLS traffic engineering fast reroutes.
Generates a trap for MPLS label distribution protocol changes.
Generates a trap for MPLS traffic engineering changes.
Generates a trap for MPLS Virtual Private Network (VPN) changes.
Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
Generates a trap for Open Shortest Path First (OSPF) changes. You can enable any or all of
these traps: Cisco specific, errors, link-state advertisement, rate limit, retransmit, and state
changes.
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can enable any or
all of these traps: invalid PIM messages, neighbor changes, and rendezvous point
(RP)-mapping changes.
Generates a trap for the SNMP Response Time Reporter (RTR).
Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link
up or link down.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring SNMP
25-13
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
