Cisco 3845 - Security Bundle Router Software Manual page 281
Software configuration guide
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Manual (94 pages) ,
- Quick start manual (38 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Chapter 13
Configuring STP
Beginning in privileged EXEC mode, follow these steps to configure the port priority of a spanning-tree
port. This procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
spanning-tree port-priority priority
Step 4
spanning-tree vlan vlan-id port-priority priority
Step 5
end
Step 6
show spanning-tree interface interface-id
or
show spanning-tree vlan vlan-id
Step 7
copy running-config startup-config
Note
The show spanning-tree interface interface-id privileged EXEC command displays information only
if the port is in a link-up operative state. Otherwise, you can use the show running-config interface
privileged EXEC command to confirm the configuration.
To return to the default spanning-tree setting, use the no spanning-tree [vlan vlan-id] port-priority
interface configuration command. For information on how to configure load sharing on trunk ports by
using spanning-tree port priorities, see the
page
OL-23400-01
10-14.
Purpose
Enter global configuration mode.
Specify an interface to configure, and enter interface
configuration mode.
If the interface is a VLAN, only ports with
Note
spanning tree enabled in the VLAN will run
spanning tree.
If the interface is a port channel, all members of the
port channel must be have spanning tree enabled.
Configure the port priority for the spanning-tree port.
For priority, the range is 0 to 240, in increments of 16; the
default is 128. Valid values are 0, 16, 32, 48, 64, 80, 96,
112, 128, 144, 160, 176, 192, 208, 224, and 240. All other
values are rejected. The lower the number, the higher the
priority.
Configure the port priority for a VLAN.
For vlan-id, you can specify a single VLAN identified
•
by VLAN ID number, a range of VLANs separated by
a hyphen, or a series of VLANs separated by a comma.
The range is 1 to 4094.
For priority, the range is 0 to 240, in increments of 16;
•
the default is 128. Valid values are 0, 16, 32, 48, 64, 80,
96, 112, 128, 144, 160, 176, 192, 208, 224, and 240.
All other values are rejected. The lower the number,
the higher the priority.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
"Configuring Trunk Ports for Load Sharing" section on
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring Spanning-Tree Features
13-17
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
