Blocking State - Cisco 3845 - Security Bundle Router Software Manual
Software configuration guide
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Manual (94 pages) ,
- Quick start manual (38 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Chapter 13
Configuring STP
Figure 13-1
Figure 13-1
Power-on
initialization
Forwarding
When you power up the switch, spanning tree is enabled by default, and every port on the switch, as well
as any other port in other switches in the VLAN or network that are participating in spanning tree, goes
through the blocking state and the transitory states of listening and learning. Spanning tree stabilizes
each interface at the forwarding or blocking state.
When the spanning-tree algorithm places a Layer 2 spanning-tree interface in the forwarding state, this
process occurs:
1.
2.
3.
4.
Blocking State
A Layer 2 interface in the blocking state does not participate in frame forwarding. After initialization, a
BPDU is sent to each switch interface, or to each switch STP port. A switch initially functions as the
root until it exchanges BPDUs with other switches. This exchange establishes which switch in the
network is the root or root switch. If there is only one switch in the network, no exchange occurs, the
forward-delay timer expires, and the interface moves to the listening state. An interface participating in
spanning tree always enters the blocking state after switch initialization.
An interface in the blocking state performs these functions:
•
•
•
•
OL-23400-01
shows how an interface moves through the states.
Spanning-Tree Interface States
Blocking
state
Listening
Disabled
state
state
Learning
state
state
The interface is in the listening state while spanning tree waits for protocol information to transition
the interface to the blocking state.
While spanning tree waits the forward-delay timer to expire, it moves the interface to the learning
state and resets the forward-delay timer.
In the learning state, the interface continues to block frame forwarding as the switch learns
end-station location information for the forwarding database.
When the forward-delay timer expires, spanning tree moves the interface to the forwarding state,
where both learning and frame forwarding are enabled.
Discards frames received on the interface
Discards frames switched from another interface for forwarding
Does not learn addresses
Receives BPDUs
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Understanding Spanning-Tree Features
13-5
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
