Chapter 30
Configuring HSRP
Configuring HSRP
•
•
•
•
•
•
•
Default HSRP Configuration
Table 30-1
Feature
HSRP version
HSRP groups
Standby group number
Standby MAC address
Standby priority
Standby delay
Standby track interface priority
Standby hello time
Standby holdtime
HSRP Configuration Guidelines
•
•
•
OL-23400-01
Default HSRP Configuration, page 30-5
HSRP Configuration Guidelines, page 30-5
Enabling HSRP, page 30-6
Configuring HSRP Priority, page 30-7
Configuring MHSRP, page 30-9
Configuring HSRP Authentication and Timers, page 30-10
Enabling HSRP Support for ICMP Redirect Messages, page 30-11
Default HSRP Configuration
HSRP can be configured on a maximum of 32 VLAN or routing interfaces.
In the procedures, the specified interface must be one of these Layer 3 interfaces:
–
Routed port: a physical port configured as a Layer 3 port by entering the no switchport
interface configuration command.
–
SVI: a VLAN interface created by using the interface vlan vlan_id global configuration
command and by default a Layer 3 interface.
Etherchannel port channel in Layer 3 mode: a port-channel logical interface created by using
–
the interface port-channel port-channel-number global configuration command and binding
the Ethernet interface into the channel group. For more information, see the
Layer 3 EtherChannels" section on page
All Layer 3 interfaces must have IP addresses assigned to them. See the
Interfaces" section on page
Default Setting
Version 1
None configured
0
System assigned as: 0000.0c07.acXX, where XX is the HSRP
group number
100
0 (no delay)
10
3 seconds
10 seconds
28-12.
9-19.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring HSRP
"Configuring
"Configuring Layer 3
30-5