Enabling Udld Globally; Enabling Udld On An Interface - Cisco 3845 - Security Bundle Router Software Manual
Software configuration guide
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Manual (94 pages) ,
- Quick start manual (38 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Chapter 22
Configuring UDLD
Enabling UDLD Globally
Beginning in privileged EXEC mode, follow these steps to enable UDLD in the aggressive or normal
mode and to set the configurable message timer on all fiber-optic ports on the switch:
Command
Step 1
configure terminal
Step 2
udld {aggressive | enable | message time
message-timer-interval}
Step 3
end
Step 4
show udld
Step 5
copy running-config startup-config
To disable UDLD globally, use the no udld enable global configuration command to disable normal
mode UDLD on all fiber-optic ports. Use the no udld aggressive global configuration command to
disable aggressive mode UDLD on all fiber-optic ports.
Enabling UDLD on an Interface
Beginning in privileged EXEC mode, follow these steps either to enable UDLD in the aggressive or
normal mode or to disable UDLD on a port:
Command
Step 1
configure terminal
Step 2
interface interface-id
OL-23400-01
Purpose
Enter global configuration mode.
Specify the UDLD mode of operation:
aggressive—Enables UDLD in aggressive mode on all fiber-optic
•
ports.
•
enable—Enables UDLD in normal mode on all fiber-optic ports on
the switch. UDLD is disabled by default.
An individual interface configuration overrides the setting of the
udld enable global configuration command.
For more information about aggressive and normal modes, see the
"Modes of Operation" section on page
message time message-timer-interval—Configures the period of
•
time between UDLD probe messages on ports that are in the
advertisement phase and are detected to be bidirectional. The range
is from 7 to 90 seconds.
This command affects fiber-optic ports only. Use the udld
Note
interface configuration command to enable UDLD on other port
types. For more information, see the
Interface" section on page
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the port to be enabled for UDLD, and enter interface
configuration mode.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring UDLD
22-1.
"Enabling UDLD on an
22-5.
22-5
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
