Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 45
Etherswitch interface cards
Hide thumbs
Also See for HWIC-4ESW - EtherSwitch HWIC Switch:
- Supplementary manual (2 pages) ,
- User manual (118 pages)
Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
monitor session 1 {source {interface
interface-id} | {vlan vlan-id}} [, | - | rx |
tx | both]
Example:
Router(config)# monitor session 1 source
interface fastethernet 0/3/1
Configuring SPAN Destinations
To configure the destination for a SPAN session, use the following commands.
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
enable
configure terminal
monitor session session-id {destination {interface type interface-id} [, | -] | {vlan vlan-id}}
end
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Specifies the SPAN session (number 1), the source
interfaces or VLANs, and the traffic direction to be
monitored.
•
The example shows how to configure the SPAN session
to monitor bidirectional traffic from source interface
Fast Ethernet 0/3/1.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
How to Configure EtherSwitch HWICs
45
Advertisement
Chapters
Table of Contents
