Table of Contents
Advertisement
Installing the CTX2500 Card in the
Cisco ONS 15310-MA
Product Names: 15310-CTX-2500-K9
This document provides a card description, specifications, and an installation procedure for the
Cisco ONS 15310-MA CTX2500 card. As appropriate use this document in conjunction with the
Cisco ONS 15310-CL and Cisco ONS 15310-MA Procedure Guide, the Cisco ONS 15310-CL and
Cisco ONS 15310-MA Reference Manual, and the Cisco ONS 15310-CL and Cisco ONS 15310-MA
Troubleshooting Guide when working with CTX2500 cards.
This document contains the following sections:
•
•
•
•
•
•
CTX2500 Card Description
The CTX2500 card, for use with the ONS 15310-MA, is a fully nonblocking cross-connect card that
operates in either a simplex or duplex (redundant) configuration. It performs system initialization,
provisioning, alarm reporting, maintenance, diagnostics, IP address detection/resolution, SONET DCC
termination, system fault detection, and cross-connect maintenance and management for the
ONS 15310-MA. The card also provides the circuitry for the OC-3/OC-12/OC-48 interfaces, and
ensures that the system maintains timing with SMC stability.
If the system loses power or the CTX2500 card is reset, you must reset the ONS 15310-MA clock unless
Caution
the node has been previously provisioned to use Simple Network Time Protocol (SNTP) to update the
clock over the LAN.
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2006 Cisco Systems, Inc. All rights reserved.
CTX2500 Card Description, page 1
CTX2500 Card Specifications, page 3
Install the CTX2500 Cards, page 5
Related Documentation, page 7
Obtaining Documentation, page 7
Obtaining Technical Assistance, page 8
Advertisement
Table of Contents
Related Manuals for Cisco CTX2500
Summary of Contents for Cisco CTX2500
-
Page 1: Table Of Contents
ONS 15310-MA. The card also provides the circuitry for the OC-3/OC-12/OC-48 interfaces, and ensures that the system maintains timing with SMC stability. If the system loses power or the CTX2500 card is reset, you must reset the ONS 15310-MA clock unless Caution the node has been previously provisioned to use Simple Network Time Protocol (SNTP) to update the clock over the LAN. - Page 2 The CTX2500 supports errorless side switches (switching from one CTX2500 on one side of the shelf to the other CTX2500 on the other side of the shelf) when the switch is initiated through software or is caused by a software upgrade.
-
Page 3: Ctx2500 Card Specifications
FAIL LED turns on and flashes until the software deems the card operational. ACT/STBY LED The ACT/STBY LED is green if the card is the active CTX2500 card. It is (Green/Amber) amber if the card is the standby card. -
Page 4: Lan Port
Transmitter • Maximum transmitter output power: Depends on the SFP used – (see the SFP specifications in the Cisco ONS 15310-CL and Cisco ONS 15310-MA Reference Manual) – Minimum transmitter output power: Depends on the SFP used (see the SFP specifications in the Cisco ONS 15310-CL and Cisco ONS 15310-MA Reference... -
Page 5: Install The Ctx2500 Cards
Use of controls, adjustments, or performing procedures other than those specified may result in Warning hazardous radiation exposure. Statement 1057 Do not install a CTX2500 card in an ONS 15310-MA if the ambient temperature exceeds 149 degrees F Caution (65 degrees C). - Page 6 Verify that the card is inserted correctly and close the ejector on the card. The CTX2500 cards are hot-pluggable, so they can be inserted or removed without turning off Note the power to the ONS 15310-MA.
-
Page 7: Related Documentation
These sections explain how to obtain technical information from Cisco Systems. Cisco.com You can access the most current Cisco documentation on the World Wide Web at this URL: http://www.cisco.com/univercd/home/home.htm You can access the Cisco website at this URL: http://www.cisco.com... -
Page 8: Documentation Feedback
The Cisco TAC website is located at this URL: http://www.cisco.com/tac Accessing all the tools on the Cisco TAC website requires a Cisco.com user ID and password. If you have a valid service contract but do not have a login ID or password, register at this URL: http://tools.cisco.com/RPF/register/register.do... -
Page 9: Obtaining Additional Publications And Information
For P1 or P2 cases (P1 and P2 cases are those in which your production network is down or severely degraded) or if you do not have Internet access, contact Cisco TAC by telephone. Cisco TAC engineers are assigned immediately to P1 and P2 cases to help keep your business operations running smoothly. - Page 10 Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Access Registrar, Aironet, BPX, Catalyst, CCDA, CCDP, CCIE, CCIP, CCNA, CCNP, Cisco, the Cisco Certified Internetwork Expert logo, Cisco IOS, Cisco Press, Cisco Systems, Cisco Systems Capital,...