Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 19
Etherswitch interface cards
Hide thumbs
Also See for HWIC-4ESW - EtherSwitch HWIC Switch:
- Supplementary manual (2 pages) ,
- User manual (118 pages)
Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Command or Action
Step 6
switchport access vlan vlan-number
Example:
Router(config-if)# switchport access vlan 1
Step 7
no shutdown
Example:
Router(config-if)# no shutdown
Step 8
end
Example:
Router(config-if)# end
Configuring 802.1x Authentication
•
•
•
•
•
•
•
•
•
Enabling 802.1x Authentication
To enable 802.1x port-based authentication, you must enable AAA and specify the authentication
method list. A method list describes the sequence and authentication methods to be queried to
authenticate a user.
The software uses the first method listed to authenticate users; if that method fails to respond, the
software selects the next authentication method in the method list. This process continues until there is
successful communication with a listed authentication method or until all defined methods are
exhausted. If authentication fails at any point in this cycle, the authentication process stops, and no other
authentication methods are attempted.
For additional information on default 802.1x configuration refer
on page
Complete these steps to configure 802.1x port-based authentication. This procedure is required.
SUMMARY STEPS
1.
2.
Enabling 802.1x Authentication, page 19
Configuring the Switch-to-RADIUS-Server Communication, page 21
Enabling Periodic Reauthentication, page 23
Changing the Quiet Period, page 24
Changing the Switch-to-Client Retransmission Time, page 25
Setting the Switch-to-Client Frame-Retransmission Number, page 26
Enabling Multiple Hosts, page 27
Resetting the 802.1x Configuration to the Default Values, page 28
Displaying 802.1x Statistics and Status, page 29
5.
enable
configure terminal
Purpose
For access ports, specifies the access VLAN.
•
Enter the VLAN number.
Activates the interface.
Required only if you shut down the interface.
•
Exits configuration mode.
"Default 802.1x Configuration" section
How to Configure EtherSwitch HWICs
19
Advertisement
Chapters
Table of Contents
