Table of Contents
Advertisement
Connecting the Power
Connecting the Power
Cisco uBR7100 series routers feature four-output switching AC power supplies that provide power
factor correction and regulated outputs. Cisco uBR7100 series routers have one AC-input power supply.
For information on the power supply specifications, see
Note
Warning
Do not touch the power supply when the power cord is connected. For systems with a power switch,
line voltages are present within the power supply even when the power switch is off and the power
cord is connected. For systems without a power switch, line voltages are present within the power
supply when the power cord is connected. Statement 4
Check the following conditions before you start the router:
•
•
•
•
To connect the AC power on Cisco uBR7100 series routers, use the following procedure:
At the back of the router, check that the power switch is in the OFF (O) position.
Step 1
Connect one end of the power cord to the power connector on the back of the router. (See
Step 2
Connect the other end of the power cord to the power outlet.
Step 3
Figure 3-13 Connecting the AC Power Cord
5
I
For information on system startup and software configuration, see
Note
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
3-12
The port adapter is securely inserted in its slot.
All network interface cables are connected.
A flash disk or flash memory card is installed in its PC Card slot.
The console terminal is connected and powered on.
SLOT 0
ACT ACT
DS0
LNK
FE 0/0
FE 0/1
1
RF
DS0
US3
US2
US1
Chapter 3
Installing Cisco uBR7100 Series Universal Broadband Routers
SLOT 1
PWR
PWR
SYS
CONS
RDY
AUX
US0
EN
uBR711 4
Appendix A, "System
Specifications".
Chapter 4, "System Startup."
Figure
3-13.)
OL-5916-01
Advertisement
Table of Contents
Troubleshooting
