Table of Contents
Advertisement
Starting the System
Starting the System
After installing the router and connecting cables, start the router as follows:
At the back of the router, place the power switch on the power supply in the ON (|) position. The green
Step 1
power (PWR) LED on the router comes on.
Listen for the fans; you should immediately hear them operating.
Step 2
During the boot process, observe the system LEDs. The LEDs on the fixed interfaces and the modular
Step 3
port adapter go on and off in irregular sequence. Some may go on, go out, and go on again for a short
time.
Observe the initialization process. When the system boot is complete (a few seconds), the network
Step 4
processor begins to initialize the interfaces. During this initialization, the LEDs on each port behave
differently (most flash on and off).
The enabled LED on each interface goes on when initialization is completed, and the console screen
displays a system banner similar to the following:
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
When you start up the router for the first time, the system automatically enters the setup command
Step 5
facility, which determines which interfaces are installed and prompts you for configuration information
for each one. On the console terminal, after the system displays the system banner and hardware
configuration, you see the following System Configuration Dialog prompt:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
You have the following options:
•
•
Note
If the system does not complete each of the steps in the startup procedure, proceed to
"Troubleshooting the Installation,"
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
4-2
Restricted Rights Legend
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Enter yes to proceed with the setup facility to configure the router's interfaces
Enter no to exit the setup procedure, and instead proceed to use command line interface (CLI)
configuration commands to configure the global (system-wide) and interface-specific parameters.
You do not have to configure the interfaces immediately; however, you cannot enable the
interfaces or connect them to any networks until you have configured them.
for troubleshooting recommendations and procedures.
Chapter 4
System Startup
Chapter 5,
OL-5916-01
Advertisement
Table of Contents
Troubleshooting
