Table of Contents
Advertisement
New Specialty Color Toner Installation Procedure
1.
Install the dispenser.
(1) Remove the new dispenser from the storage box.
(2) Install the dispenser on the printer. During this step, 10 cm before the dispenser is
completely pushed in, detach the joint pipe fixture and lower it downwards.
(3) Insert the dispenser as far as it can go and fix it in place. Fix the upper section with the two
screws that were placed on the upper lid of the storage box, and tighten the loose screws of
the joint pipe section to fix the section in place.
When holding the dispenser, take care not to touch the motor or
connectors at its rear.
If the screws fall inside the machine, contact your dealer or nearest
SHARP Service Department.
27
Fixture
Advertisement
Table of Contents
