Table of Contents
Advertisement
(2) Hold the new marking module assembly by holding the handle at the front with your right
hand and the notched section of metal plate at the rear with your left hand.
When holding the marking module assembly, do not hold it by the
pin at its rear.
The pin might break and the marking module assembly might fall.
(3) Place the marking module assembly on the slide rails beginning with the left side of the
slide rails in the printer.
Insert the marking module assembly into the inside of the slide rails until the assembly is
locked by the lock brackets.
Make sure that the marking module assembly is properly fitted on the
slide rails.
29
Advertisement
Table of Contents
