17. Remove the dispenser.
(1) Remove the two dispenser fixing screws marked in yellow, and loosen the joint pipe section
screw marked in red. After removing the two screws, place them on the upper lid of the
storage box.
(2) Draw out the dispenser to the front by 10 cm while slightly lifting up its front section, and
turn the joint pipe counterclockwise to fix it in place.
(3) Draw out the dispenser while taking care to prevent it from tilting, and place it on the upper
lid of the storage box.
If the screws fall inside the machine, contact your dealer or nearest
SHARP Service Department.
When holding the dispenser, take care not to touch the motor or
connectors at its rear. Take care when handling the dispenser as
toner might spill out if the dispenser is tilted or put on its side.
26