Table of Contents
Advertisement
(3) If the marking module assembly cannot go as far as it can when it is pushed into the printer,
rotate the flange (black part) approximately 30° clockwise and push it in again.
Repeat this step until the marking module assembly is properly loaded.
7.
Fix the marking module assembly in place with screws. After tightening the two screws at the top,
temporarily fasten the flange screw (screw at the bottom), and then tighten the screw by using
the flange restrainer.
• Do not draw out the marking module assembly too far.
• Do not touch the blue part of the marking module assembly.
• Do not rotate the flange counterclockwise.
Flange
Blue part
32
Advertisement
Table of Contents
