Advertisement
[4] UNPACKING AND INSTALLATION
1.AR-D13
<Before installation>
•For installation, a power supply unit (AR-DC1) is needed.
<Parts included>
Front mounting
plates: 2 pcs.
Left adjuster: 1 pc.
Adjuster covers: 4 pcs.
Left paper guides: 2 pcs.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the printer to the
"OFF" position.
Then remove the power plug from the outlet.
2) Attach the adjusters and adjust them.
<1>Insert the left adjusters to the stand/paper drawer.
<2>Turn the five adjusters to lower them until they touch the floor.
<3>Attach the four adjuster covers.
3
3
2
1
3) Put the main unit of the printer on the stand/paper drawer.
<1>Pull out the paper tray of the main unit until it stops and then remove
it by lifting both ends of the tray.
Screws: 4 pcs.
Rear mounting
plates: 2 pcs.
Right paper guides: 2 pcs.
"OFF"
3
2
2
3
2
AR-D13/D14/MU1/DC1 UNPACKING AND INSTALLATION-1
<2>Hold the main unit of the printer at the positions shown in the
illustration and put the main unit on the stand/paper drawer so that
the front side and the left side of the main unit are aligned to those of
the stand/paper drawer.
4) Connect the main unit to the stand/paper drawer.
<1>Attach the rear mounting plates with two supplied screws.
Screw
Rear mounting plate
<2>Pull out the upper paper tray of the stand/paper drawer until it stops
and attach the front mounting plates with two supplied screws.
Then, remove the lock of the paper tray and close the tray.
Front mounting
Screw
plate
<3>Reattach the paper tray of the main unit.
Front side
Rear side
Rear
mounting plate
Screw
Front
mounting plate
Screw
Advertisement
