Advertisement
<2>Pull out the paper tray of the multi purpose drawer until it stops and
attach the front mounting plates with two supplied screws.
Then, remove the lock of the paper tray and close the tray.
Front mounting plate
Screw
<3>Reattach the paper tray of the main unit of the printer.
4) Connect the harness to the main unit of the printer.
<1>Remove the screw that fixes the harness cover of the main unit of the
printer and then slide the harness cover up to remove it.
Process the harness cover as shown in the illustration.
Cut out.
<2>Connect the connector of the relay harness of the multi purpose
drawer to the connector of the PCU PWB of the main unit of the
printer.
If you do not install a finisher, saddle stitch finisher or mail-bin stacker,
the steps below are not needed. Proceed to step 10).
Front
mounting plate
Screw
Screw
Harness cover
Connector
AR-D13/D14/MU1/DC1 UNPACKING AND INSTALLATION-6
5) Remove the rear cabinet of the multi purpose drawer.
<1>Remove the two screws that fix the rear cabinet of the multi purpose
drawer and then remove the rear cabinet.
<2>Remove the screw that fixes the AC inlet cover and then remove the
AC inlet cover.
Process the AC inlet cover as shown in the illustration.
Cut out.
6) Attach the power supply unit.
Attach the power supply unit to the positioning portion of the multi
purpose drawer and then fix it with three supplied screws.
Screws
7) Connect the power supply unit harness to the PCU PWB of the main
unit of the printer.
Connect the power supply harness connector to CN11 (red
connector) of the PCU PWB of the main unit of the printer.
CN11
Screw
Rear cabinet
Screw
AC inlet cover
Screws
Optional power supply unit
Connector
Advertisement
