Cisco Firepower 2100 Series Hardware Installation Manual page 91

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Installation, Maintenance, and Upgrade

Figure 60: TELs Placement on the Chassis

TEL 1 on the left side and top of chassis

TEL 3 on the top and back of chassis

TEL 5 across the FIPS shield and the chassis (towards

the right of the chassis)

TEL 7 on the bottom of the chassis towards the right

side of the chassis

Step 8

Attach the power cable to the chassis and connect it to an electrical outlet.

Step 9

Press the power switch on the rear panel.

Step 10

Check the power LED on the front panel. See

indicates that the chassis is powered on.

Step 11

Place the chassis in FIPS mode.

See the following procedures for how to place the chassis in FIPS mode:

•

ASA in Platform Mode

•

ASA in Appliance mode

•

FTD managed by FMC

Install the FIPS Opacity Shield in a Four-Post Rack

TEL 2 on the right side and top of chassis

TEL 4 across the FIPS shield and the chassis (towards

the left of the chassis)

TEL 6 on the bottom of the chassis towards the left

side of the chassis

—

Front Panel LEDs

for a description of the power LED. Solid green

Cisco Firepower 2100 Series Hardware Installation Guide

Table of Contents