Cisco Firepower 2100 Series Hardware Installation Manual page 90

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Install the FIPS Opacity Shield in a Four-Post Rack

When you toggle the power switch from ON to OFF, it takes several seconds for the system to power down.

Note

Do not remove the power cable until the power LED is off. After removing power from the chassis either by

moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before turning power

back ON.

Step 4

Route the cables through the openings in the cable management brackets (see figure below).

Step 5

Attach the FIPS opacity shield to the cable management brackets using the four 8-32 x 0.375 inch Phillips screws

provided in the FIPS kit.

Figure 59: Route the Cables and Attach the Screws

FIPS opacity shield

Cable management bracket

Step 6

Before you attach the TELs, clean the chassis of any grease, dirt, or oil with alcohol-based cleaning pads.

Step 7

Attach the seven TELs. See the figure below for the correct placement. Allow the TELs to cure for a minimum of 12

hours.

Caution

Any deviation in the placement of the TELs means the chassis is not in FIPS mode.

Cisco Firepower 2100 Series Hardware Installation Guide

Installation, Maintenance, and Upgrade

8-32 x 0.375 inch-Phillips screws (two per side)

Table of Contents