Connect The Dc Power Supply Module - Cisco Firepower 2100 Series Hardware Installation Manual

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Installation, Maintenance, and Upgrade

Figure 49: Remove the Power Supply Module

Power supply module 1

Power supply module latch

If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;

otherwise, install another power supply module.

Step 5

To replace a power supply module, hold the power supply module with both hands and slide it into the power supply

module bay.

Step 6

Push in the power supply module gently until you hear the latch engage and it is seated.

Step 7

Plug in the power supply cable.

Step 8

Check the LED on the power supply to make sure the power supply is operative. See

27.

Connect the DC Power Supply Module

For the Firepower 2130 and 2140, the input connector and plug must be UL-recognized under UL 486 for

field wiring. The connection polarity is from left to right: negative (–), positive (+), and ground.

Use the handle on the power supply for installation and removal. You must support the module with one hand

because of its length.

Power supply module handle

Power supply module 2

Cisco Firepower 2100 Series Hardware Installation Guide

Power Supply Modules, on page

Table of Contents