Cisco Firepower 2100 Series Hardware Installation Manual page 24

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

10-Gb Network Module

Note

Make sure you have the correct firmware package and software version installed to support this network

module. See

for the procedure to verify your firmware package and software version. See

Platform Mode FXOS Configuration Guide

2100 running ASA with FXOS. See the

guide, which provide Cisco software and hardware compatibility, including operating system and hosting

environment requirements, for each supported version

Note

The FPR2K-NM-8X10G is NEBS-compliant.

Note

You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be

populated at the same time, because of the port row spacing.

Figure 15: FPR2K-NM-8X10G

Captive screw/handle

Ethernet X/3

Ethernet X/7

Ethernet X/4

Ethernet X/8

Cisco Firepower 2100 Series Hardware Installation Guide

Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 with Firepower Threat Defense

Cisco Firepower Compatibility Guide

for the procedure to upgrade the firmware package for the Firepower

Ethernet X/1

Ethernet X/5

Ethernet X/2

Ethernet X/6

Network activity LEDs

• Off—No connection or port is not in use.

• Amber—No link or network failure.

• Green—Link up.

• Green, flashing—Network activity.

Overview

Cisco Firepower 2100 ASA

and the

Cisco ASA Compatibility

Table of Contents