Cisco Firepower 2100 Series Hardware Installation Manual page 85

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Installation, Maintenance, and Upgrade

Warning

Step 1

Have the fan tray ready for immediate insertion and near the appliance so that you can reinstall the fan tray within 30

seconds.

Step 2

To remove a fan tray, face the rear of the chassis, and loosen the two captive screws on the fan tray.

Step 3

Pull the fan tray out of the chassis.

Figure 56: Remove the Fan Tray

Step 4

To replace a fan tray, hold the fan tray in front of the fan slot.

Step 5

Push the fan tray into the chassis until it is properly seated, and tighten the captive screws.

Statement 1089 Instructed and Skilled Person Definitions

An instructed person is someone who has been instructed and trained by a skilled person and takes the

necessary precautions when working with equipment.

A skilled person or qualified personnel is someone who has training or experience in the equipment

technology and understands potential hazards when working with equipment.

Statement 1090 Installation by Skilled Person

Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089

for the definition of a skilled person.

Statement 1091 Installation by an Instructed Person

Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.

See statement 1089 for the definition of an instructed or skilled person.

Cisco Firepower 2100 Series Hardware Installation Guide

Remove and Replace the Fan Tray

Table of Contents