Cisco Firepower 2100 Series Hardware Installation Manual page 17
Hide thumbs
Also See for Firepower 2100 Series:
- Getting started manual (104 pages) ,
- Hardware installation manual (84 pages) ,
- Manual (12 pages)
Table of Contents
Advertisement
Overview
1
PWR
3
Ethernet Speed
• Off—Input power is not detected. Standby
power is off.
• Green, flashing—System has detected a
power switch toggle event, and initiated the
shutdown sequence.
If the power switch is in the OFF
Note
position, the system powers off
after shutdown is completed. Do
not remove the AC or DC power
source while this LED is blinking
so that the system has time to
perform a graceful shutdown.
• Amber—System is powering up (before the
BIOS boots). This takes one to five seconds
at most.
• Green—System is fully powered up.
• Green, flashing—The number of flashes
determines link speed; 1 flash=10 Mbit,
2=100 Mbit, 3=1 Gbit.
2
Ethernet Link
• Green—The link partner is detected; no
activity.
• Green, flashing—Network activity is
detected.
4
Locator
• Off—Locate is off.
• Blue—Locate is on.
The Locator LED helps you locate a
Note
unit that needs physical service
attention. This feature is activated in
the software.
Cisco Firepower 2100 Series Hardware Installation Guide
Front Panel LEDs
13
Advertisement
Table of Contents
