Cisco Radio Transceivers - Cisco FM1200 Installation And Configuration Manual

Hide thumbs Also See for FM1200:

Table of Contents

The default IP address for all Cisco devices is 192.168.0.10 /

255.255.255.0.

You can configure any Ethernet device manually or automatically, using a

DHCP server that resides on the LAN network. The Cisco network is

totally transparent to DHCP, therefore, DHCP requests and responses can

be forwarded transparently across the network.

IMPORTANT

If an Ethernet-based system using multiple peripheral

components is connected to the wireless network, assign each

peripheral component a fixed IP address. If dynamic IP

addressing is used, the components may not be accessible to

third-party software that relies on the components for data

input.

A typical example is a video surveillance system equipped with

multiple CCTV cameras. Each camera must be assigned a

fixed IP address to be accessible to the video-recording

software.

Cisco radio transceivers

A wide variety of Ethernet edge devices, such as IP cameras and Wi-Fi

access points, can be connected to the Ethernet ports of the Cisco

FM1200 Volo. You can configure any Ethernet device manually or

automatically by using a DHCP server that resides on the LAN network.

The Cisco network is totally transparent to DHCP. Therefore, DHCP

requests and responses can be forwarded transparently across the

network.

IMPORTANT

If a video surveillance system is connected to the wireless

network, assign each camera a fixed IP address. If dynamic IP

addressing is used, the cameras may not be accessible to the

video-recording software.

Getting Started

Page 23 of 175

Table of Contents

Fm1200v-hw