Using Snmp V2C - Cisco FM1200 Installation And Configuration Manual
Hide thumbs
Also See for FM1200:
- Installation and configuration manual (174 pages) ,
- Installation and configuration manual (189 pages)
Table of Contents
Advertisement
Figure 43. SNMP dialog (SNMP disabled)
Using SNMP v2c
To change the unit's SNMP mode to v2c and configure the unit
accordingly, do the following steps:
1.
Click the
• The SNMP v2c settings dialog will be shown
(page
Figure 44. SNMP dialog (v2c selected)
2.
Enter a community identity value in the
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
By default, Cisco units are shipped from the
factory with SNMP disabled.
SNMP mode drop-down, and click the v2c option.
105)).
IMPORTANT
The same community identity value must be set for
all Cisco units in the wireless network.
(Figure 44
Community ID: field.
Page 105 of 175
Advertisement
Table of Contents
