Cisco FM1200 Installation And Configuration Manual page 77

Hide thumbs Also See for FM1200:

Table of Contents

• The device label, corresponding to the device's name

configuration parameter (Alexa in the image above).

• If the device is a mobile radio transceiver, the device's

Primary/Subordinate setting will be shown. A Primary

device is marked M, and a Subordinate device is marked S.

• The device's IP address.

• If the device is a stationary mesh end, it will be marked ME. If

it is a stationary mesh point, it will be marked MP. If it is a

mobile radio, the RSSI (in dBm) between the radio and the

stationary radio to which it is connected will be shown.

• If the device does not currently have a configured IP address

or device label, the device's Cisco Mesh ID number will be

shown.

• If the network is a Fluidity network, mobile Cisco radio

transceivers that are part of the network are shown as

tool tips with colored borders. The tool tip representing

amobile Cisco radio is always shown below the tool tip of

Device configuration using the configurator interface

• The icon below will be shown if the device is a

stationary radiodevice that is part of a Fluidity network:

• The dynamic Wi-Fi reception-style icon below will be

shown if the radio device is a mobile device that is part

of a Fluidity network. This icon shows whether the

radio's current RSSI is weak, acceptable or strong.

• The icon below will be shown if the device is an Ultra-

reliable Wireless Backhaul Gateway device.

Page 77 of 175

Table of Contents

Fm1200v-hw