Cisco FM1200 Installation And Configuration Manual page 113
Hide thumbs
Also See for FM1200:
- Installation and configuration manual (174 pages) ,
- Installation and configuration manual (189 pages)
Table of Contents
Advertisement
IMPORTANT
The RADIUS feature is only available if the Cisco FM1200 Volo
is set to Mesh Point mode or Mesh End mode. If the unit is
set to Bridge mode, the -radius menu option will not be
available.
The RADIUS functionality will fail to operate if the network time
protocol (NTP) feature is not enabled and configured.
IMPORTANT
Use of this window requires extensive familiarity with the
RADIUS networking protocol. Do not change these settings
unless there is a specific need to do so.
To change the RADIUS settings for the Cisco unit, do the following
steps:
1.
Enable and configure network time protocol (NTP) as shown in
"NTP Configuration" (page
2.
Click the -radius link under ADVANCED SETTINGS in the left-
hand settings menu.
• The RADIUS dialog will be shown
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
116).
(Figure 46 (page
114)).
Page 113 of 175
Advertisement
Table of Contents
