Resetting The Unit To Factory Settings - Cisco FM1200 Installation And Configuration Manual

Hide thumbs Also See for FM1200:

Table of Contents

Figure 9. Cisco FM1200 Volo (Hardware RESET button port)

Press the RESET button for one second, then release the button

immediately.

• The unit will reboot.

Resetting the unit to factory settings

CAUTION

Do not do a factory reset unless the unit needs to be

reconfigured using its factory configuration as a starting point.

A factory reset will reset the unit's IP address and administrator

password, and will disconnect the unit from the network.

The following methods are available to do a factory reset:

1. To do the reset using the offline Configurator interface, refer to

"Resetting the unit to factory defaults" (page

2. To do the reset using FM Racer, refer to the Cisco Networks FM

Racer User Manual.

3. To do the reset by physically accessing the unit, follow the

procedure below.

To reset the radio to its factory default settings, do the steps that follow:

Power ON the unit.

Wait approximately 40 seconds for the unit to boot up.

When the unit has completed its boot sequence, press the

RESET button for 7 seconds.

• The LEDs will blink.

• The unit will be restored to factory default settings

(including its default IP address of 192.168.0.10 and

subnet mask of 255.255.255.0).

• The unit will reboot.

Hardware installation

138).

Page 35 of 175

Table of Contents

Fm1200v-hw