Table of Contents
Advertisement
Alternatively, enter Edit mode by clicking the Settings icon on the
upper right part of the FM-QUADRO view, and clicking the Edit
Mode switch in the Appearance / Background dialog from Off to
On.
• The Edit mode dialog will be shown.
2.
Click the Continue to Edit Mode button to enable Edit Mode.
• A red Edit Mode: ON notification will appear in the view.
3.
Click-and-drag any of the stationary device icons or tooltips to
any needed position in the FM-QUADRO view.
• Note that tooltips representing mobile radios do not appear
in Edit Mode.
4.
When all device icons and tooltips are in the correct position, click
the Save or discard icon (below).
• The Save new layout dialog will be shown.
5.
To save your changes, click the Save changes button.
Alternatively, click the Keep editing button to return to Edit Mode,
or click the Discard button to leave Edit Mode without saving any
changes.
Showing KPI values for wireless links
To show an information ribbon containing key performance indicators next
to all wireless link lines, do the steps that follow:
1.
Click the Settings icon on the upper right part of the FM-
QUADRO view (below).
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
TIP
If needed, you can add an aerial image to the
FM-QUADRO view. This allows you to
superimpose the network view over a map of
the terrain on which the network has been
installed.
For instructions on how to add an aerial
image, refer to
"Adding an aerial map to the
FM-QUADRO view" (page
86).
Page 85 of 174
Advertisement
Table of Contents
