Table of Contents
Advertisement
for 24 hours, followed by a 24-hour drying time. The unit was then
carefully examined to verify that no corrosion or water ingress were
found.
• Verification of resistance to fluctuating temperatures. This consisted
of placing the unit in a climatic chamber and subjecting it to
operating ranges between -40°C and 80°C, for four hours.
5.2. Connecting the Fluidmesh Cisco FM4500 Mobi to a
network and antennas
5.2.1. Terminal assignments for power and data connectors
IMPORTANT
Always use outdoor-rated, RF-shielded Ethernet cables when
connecting the Power and LAN ports of a Fluidmesh hardware
device to external hardware.
M12 A-coded
This section describes the terminal assignments for M12 A-coded
connectors equipped with five pins (power only) and with eight pins
(power and data).
M12 A-coded (five-pin)
The terminal assignments for female M12 A-coded five-pin connectors are
as follows:
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
Page 32 of 174
Advertisement
Table of Contents
