Table of Contents
Advertisement
Figure 41. SNMP dialog (SNMP disabled)
Using SNMP v2c
To change the unit's SNMP mode to v2c and configure the unit
accordingly, do the following steps:
1.
Click the SNMP mode drop-down, and click the v2c option.
• The SNMP v2c settings dialog will be shown
(page
Figure 42. SNMP dialog (v2c selected)
2.
Enter a community identity value in the Community ID: field.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
By default, Fluidmesh units are shipped from the
factory with SNMP disabled.
106)).
IMPORTANT
The same community identity value must be set for
all Fluidmesh units in the wireless network.
(Figure 42
Page 106 of 174
Advertisement
Table of Contents
