Port Licensing - Cisco ASR 900 Series Configuration Manual
1 port oc48/ 4 port oc12/oc3 + 12 port t1/e1 + 4 port t3/e3 cem interface module
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Port Licensing
• E1/E3, Unidirectional Path Switching Ring (UPSR), and Data Communication Channel (DCC) are not
• Multiservice functionality: PPP, MLPPP, FR, and MLFR are not supported.
• EoS and EoPDH are not supported.
• The IM is only supported on Cisco RSP2 Module.
• The configure replace command is not supported on the T1/E1 interface modules.
• A combination of T1/T3/SONET with E1/E3/SDH modes are not supported.
Port Licensing
The Cisco Software License Activation feature is a set of processes and components to activate Cisco IOS-XE
software feature sets by obtaining and validating fee-based Cisco software licenses.You should enable the
license only for OCx ports. License is not required for the ports 0-15 (DSx ports).
You should associate a required license to a port. Many licenses can be configured for a port. Only one license
can be associated with a port as only one rate can be configured at a time. Other licenses are not required
unless rate is changed frequently.
No license is enabled on the port by default. Same port license (OC-3 or OC-12) can be used for Legacy OC-3
IM. A port can be enabled with any one of the following license types:
• OC-3
• OC-12
• OC-48
On each IM, OCx port can be configured on ports 16-19. For example, a maximum of four OC-3 ports can
be configured on ports 16-19. A maximum of four OC-12 ports can be configured on ports 16-19. A maximum
of one OC-48 port can be configured on ports 16-19.
Information About Port Licensing
Scenario of IM Removal
• All licenses enabled on the IM ports are removed.
• The free licenses can be associated with the same or different IM ports.
Scenario of IM Re-insertion
• When IM is inserted back in the same slot, the IM ports require the licenses based on the configurations.
• The available free licenses are used and old configurations are retained.
• When free licenses are not available, the controller port moves to "shut" state and the following error
• To remove the "shut" state, perform any one of the following actions:
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
2
Configuring Support of 1 port OC-48/ 4 port OC-12/OC-3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module
supported.
message is displayed:
Controller port does not have license so putting it into shut state. Un-shut after
enabling license or remove controller port configuration
Advertisement
Table of Contents
Troubleshooting
